PHASE 3 HUMATURE KIT - $139.75
     4.5 inches - "Bro/Sis"

Note: The shorter Humature kits still duplicate human movements, but the completed armature's proportions will not be as anatomically accurate as the 6-inch version the
Phase 3 line is based upon.

  • 4.5 inches tall
    The "Brother/Sister" version of the Phase 3 Humature is 4.5 inches tall, 1.5 inches shorter than the standard kit.

  • Fully-articulated joints / 90-degree articulation at knees and ankles
    Give your character full range of motion - attain completely realistic movement or push the boundaries of gravity and physics! New variable size dumbbell joints allow for "correct" 90-degree joint articulation where needed.
  • Isolated joint tension for most joints
    The unique design allows you to adjust individual joint tension on either end of a single limb. Different tensions can be attained on a single sandwich joint.
     
  • Limitless possibilities
    Phase 3 pieces and kits provide ultimate adaptability and interchangeability. An infinite number of character configurations size variations are possible. In addition, Phase 2 pieces and kits are completely interchangeable with Phase 3 parts.
     
  • Tie-down hardware for hands and feet
    To provide a solid base for animating, most animators choose to "tie-down" the armature while working by attaching the character’s feet, hands, claws or paws to the set floor. All the necessary hardware and instructions are included with each kit.
     
  • Stainless steel
    The sturdy figure will still hold any pose after thousands of hours of animation under hot lights. It's safe to cover with any material desired for animation from clay to foam to latex and more.
     
  • Adaptor dumbbell
    New adaptor dumbbells allow the classic Phase 2 parts to be completely interchangeable with the new Phase 2 design, as shown with the Phase 2 Armasaur and the Phase 3 Dragon Adaptor kit.

The 4.5-inch Phase 3 Humature Kit includes everything you need to start animating immediately.
Your new kit will include...

 

  • 14 3-Hole Plates

  • 4 5-Hole Plates

  • 4 Diamond Plates

  • 10 DB-1

  • 2 DB-2

  • 1 DB-A (Head)

  • 4 Ball Bearings*

  • 19 Lock washers

  • 25 Hex nuts

  • 21 10 mm screws

  • 4 20 mm screws*

  • 4 Tie-down nuts

  • 4 Threaded ball bearings

  •  Instructions

    •

 

 

 

 

 

Every Armaverse Phase 3 Humature kit comes in a special-edition all-metal package commemorating the launch of the Phase 3 Humature.

* Each Armaverse Phase 3 Humature kit contains two extra 20mm screws and two extra ball bearings to provide for greater adaptability.  The ball bearings may be used in place of dumbbell (DB) pieces or threaded ball bearings for different limb adaptations while the extra screws may come in handy for greater tie-down options.  While two threaded ball bearings are to be placed in the feet of your armature, two additional threaded ball bearings are included as an option for hand tie-down if you need to animate a handstand or cartwheel.

 

All you'll need:

1 small pair of pliers
1 Phillips-head screwdriver

Check out the Phase 3 Individual Pieces page for a closer look at all Armaverse Phase 3 parts.

Please visit the PDF page if you have any questions about Armaverse part dimensions.
 
©2004 Armaverse.  All rights reserved.  Patent pending.