 |
|
|
PHASE 3 HUMATURE KIT - $139.75
6 inches
The wait is over. A six-inch tall Humature with near-perfect human
proportions. you asked for it...you got it! We're proud to introduce
the keystone of the new Armaverse Phase 3 interchangeable armature modeling
system.
Six inches
tall
The Phase 3 Humature is a convenient six inches tall, the smallest anatomically
accurate Armaverse Humature available.
Accurate
human proportions
Painstaking design went into the production of the Phase 3 Humature in an effort to bring the figure as close to anatomical perfection as
possible.
Fully-articulated joints / 90-degree articulation at knees and ankles
Give your character full range of motion - attain completely
realistic movement or push the boundaries of gravity and physics! New variable
size dumbbell joints allow for "correct" 90-degree joint articulation
where needed.
|
Ideal head support for easy modeling or replacement animation
Interchange heads to animate speech and expressions with ease.
Isolated joint
tension for most joints
The unique design allows you to adjust individual joint tension on either end of a single limb. Different tensions can be attained on a single sandwich joint.
Limitless possibilities
Armaverse pieces and kits provide ultimate adaptability and interchangeability. An
infinite number of character configurations size variations are possible.
Tie-down hardware for hands and feet
To provide a solid base for animating, most animators choose to "tie-down" the armature while working by attaching the character’s feet, hands, claws or paws to the set floor. All the necessary hardware and instructions are included with each kit.
Stainless steel
The sturdy figure will still hold any pose after thousands of hours of animation under hot lights. It's safe to cover with any material desired for animation from clay to foam to latex and more.
Adaptor
dumbbell
Armaverse adaptor dumbbells allow each Phase to be
completely interchangeable with all other Phases.
The Phase 3 Humature Kit includes everything you need to start animating
immediately.
Your new kit will include...
|
-
10
3-Hole Plates
-
4 5-Hole Plates
-
4 7-Hole Plates
-
4 Diamond Plates
-
10 DB-1
-
2
DB-3
-
1 DB-A (Head)
-
6 Ball Bearings*
-
22 Lock washers
-
22 Hex nuts
-
22 10 mm screws
-
4 20
mm screws*
-
4 Tie-down nuts
-
4
Threaded ball bearings
-
Instructions
|
|
Every Armaverse Phase 3 Humature kit comes in a special-edition
all-metal package commemorating the launch of the Phase 3 Humature.
|
|
* Each Armaverse Phase 3
Humature kit contains two extra 20mm screws and two extra ball bearings to
provide for greater adaptability. The ball bearings may be used in place
of dumbbell (DB) pieces or threaded ball bearings for different limb adaptations
while the extra screws may come in handy for greater
tie-down options.
While two threaded ball bearings are to be placed in the feet of your armature,
two additional threaded ball bearings are included as an option for hand
tie-down if you need to animate a handstand or cartwheel.
All
you'll need:
1 small
pair of pliers
1 Phillips-head screwdriver |
|
Check out the Phase 3 Individual Pieces
page for a closer look at all Armaverse Phase 3 parts.
Please
visit the PDF page if you have any questions about
Armaverse part dimensions. |
